Exalto Emirates LLC.

0 Items

Products added to your cart

0 Items

You have no items in your shopping cart.

CMC Marine

CMC Marine

Since 1956, CMC has produced products for marine, oilfield, industrial computer, and industrial hydraulic markets. They have led the marine market with the patented Power-Lift™ jack plates for over 30 years and with the aftermarket Tilt & Trim units for over 20 years. Now all hydraulic units are driven with patented hydraulic actuators.  CMC was the originator and pioneer of providing a self-contained hydraulic jack plate.



  • Made of 6061 T6 alloy aluminium extrusions and fastened with stainless steel fasteners. Ideal for fresh or salt water use. No welds or castings to break. The dependable, self-contained and water proof hydraulic actuator has a maximum lifting capacity of 7853 pounds of thrust. More than any other transom jack. You will have no problem lifting even a V-6 300 hp max.motor at full throttle. The hydraulic actuator is mounted inside the structure of the Power-Lift, yet it is fully accessible without removing the engine. There are no hoses to contain, nor will you have to contend with mounting a pump and reservoir inside your boat, as is the need with other transom jacks. The hydraulic actuator is completely self- contained with its own fluid reservoir. It contains a permanent magnet motor for more power and constant torque. The cylinder within the actuator has twice the lifting capacity than other transom jacks on the market. It contains a no-leak seal and wiper that keeps dirt and water out of the working parts. The system is made of 100% non-ferrous material which makes it impervious to saltwater and freshwater. The patented roller design means less friction, longer wear, less maintenance, and virtually no binding problems which are common with other transom jacks. The roller assembly contains a stainless steel 3/4” pin with aluminium-bronze alloy rollers. The roller is highly impact resistant, corrosive resistant, and has a high load carrying capacity. This patented design virtually eliminates any chance of binding which is common with other transom jacks. The PL-65 is rated for V-6 motors and smaller and gives you 5” of vertical travel with 11⁄2” of adjustment on the motor bracket and 11⁄2” of adjustment on the transom bracket. A total of 8” of possible adjustment. It also can be purchased with stainless steel motor rails, Model PL-65SS (for V-8 motors 300 hp max). CMC Manual jack plates Made of 6061 T6 extruded aluminium alloy Stainless steel fasteners for maximum strength and durability Centrally located adjustment screw for positive alignment 5 1/2” and 10” Set Backs from Transom are available 5” Vertical Adjustment Designed to fit standard B.I.A. bolt pattern Aluminium models rated for up to V6 outboards Stainless model (ML-65SS, item #65212) rated for V8 outboards Two Piece Manual Features Made of 6061 T6 extruded aluminium alloy Stainless steel fasteners for maximum strength and durability 4” and 5 1/2” Set Backs from Transom are available 5” of slot adjustment at the motor mounting bracket 1-1⁄2” of adjustment at the transom bracket. 

    (8 items) from AED 7,987.00

Close

Share this page

Dear Friend,

Check out this awesome new product from Exalto Emirates!

Page: CMC Marine
Share to
Your detail
Close

Specifications

Specifications

Close